GW3-TRBO Update Notes
- Update 34 Issues Resolved
- Update 33 Issues Resolved
- Update 33 New Features
- Update 29 Issues Resolved
- Update 28 Issues Resolved
Issues Resolved in Update 34
SAC
- Fixed an issue where the Exemption list was not refreshing after a radio was Unexempted
TRBO
- Added a notification if the master peer is disconnected
- Fixed an issue where a single repeater connection was toggling between link up and link down
- Fixed an issue with busy/idle slot status logic
Issues Resolved in Update 33
Alias
- Fixed an issue where default talkgroups persistently appeared in the "IDs Show List" after deleting them from Alias
Archiver
- Settings — System ID and Packet Types: Packet types and purging types are now consistent
TRBO
- Improved "Down Network" stability logic
- Improved corruption detection logic
New Features in Update 33
Demo
- Added diagnostics to demo data
Issues Resolved in Update 29
Group
- Group Window Options: Window Options are not remembered after closing Group
New Features in Update 28
- Added MTR3000 diagnostic types
- The Activity GUI now shows all IP communication between the repeaters and GW3-TRBO to give a more complete picture of network traffic
- Trigger events now indicate when a TRBO repeater has been dropped or added
- RC will no longer allow the user to attempt to send a call alert or remote monitor command to the sending radio
Issues Resolved in Update 28
Archiver
- Settings > System ID and Packet Types: Set Purge intervals now purge database records properly
Channel
- A zone's custom idle settings will now be applied automatically to any sites added to the zone
- Busies display when repeaters with differing firmware versions are on at the same time
- Viewing Channel Activity: when importing a site in Alias, the site is now added to Channel
Connectivity
- Can now establish a connection with 1.6 firmware master using authentication key
Database
- Bigger is not always better: TRBO system events table is no longer too large
GUI Module
- System Configuration:
- Clicking the Update button no longer creates corrupt packets
- Correctly re-establishes a RDAC connection after the repeater is turned off
Halcyon
- Session Settings > Select System Zone-Site: no longer displays a link up message the first time a command is issued after opening the RC module
Help
- Online Help: only one window pops up when "F1" is pressed (instead of two)
Miscellaneous
- A script error no longer occurs at host installation from the network
- TRBO now responds to peer registration requests from 1.5 repeaters using authentication
Reports
- Call Activity > ARC Calls Report: now keeps a full history of alias changes to radio IDs and talkgroups
- Activity by Group Over Time: column headers now line up properly
- Activity by Radio Over Time: drop down menus now display correct data
SAC
- Exempting > Unexempting a Suspect: hover tooltip in Exemption list displays corrected text
Security
- Current Users tab now correctly displays any online users
SysSummary
- Private calls now display correctly System Usage by Component graphs
- Max Channels, IDs and Groups under Last 24 Hours display correctly
Trigger
- Trigger Selection Checkbox: Echo to Eventlog checkbox has gotten smarter—it now remembers the setting when it is reoponed
- Clicking Next in the setup wizard no longer returns an unhandled exception